DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-182
Operation – Deactivate
1. The extension must be idle.
2. Press !*90. The display shows:
STATUS MSG DEL
3. The telephone returns to idle.
Conditions
a) Dial Pad Key 1 is used to select special characters. Refer to the Letter Scheme feature
b) Dial * before any dial pad key to insert the numeral on the dial pad key instead of a letter in this character
position.
c) When * is pressed after a letter has been selected for this character position, the selected letter is forced
to lower case.
d) Use / to insert a space.
e) Use / to advance to the next character position.
f) Messages can be 16 letters/symbols maximum.
g) The Message – Status feature code can be stored on an available Flexible Feature Button.
h) When the Message – Status feature code is stored on a Flexible Feature Button, that button is used to
activate and deactivate the status message.
Default Settings
System Resource – Preprogrammed Message – Premises Message 1 = “Out to lunch”
System Resource – Preprogrammed Message – Premises Message 2 = “Will return soon”
System Resource – Preprogrammed Message – Premises Message 3 = “Gone for the day”
System Resource – Preprogrammed Message – Premises Message 4 = “In a meeting”
System Resource – Preprogrammed Message – Premises Message 5 = “Out of office”
System Resource – Preprogrammed Message – Premises Message 6 = “On vacation”
Programming Abstract
Change the content of preprogrammed messages as necessary.
Programming via the DET (Digital Extension Terminal)
Note: [back], [next], [show], [chg], [bksp], and [save] are LCD interactive button operations. Use the
three buttons below the LCD display to actuate the associated operation.
• Enter Database Administration using the feature code !+* and then enter the DB Admin password
“++++++++.” (Note: This eight-character password can be changed.)
• Press [show ]. The DB Item Select screen displays.
• Input 04-07-02-01, then press [save]. This advances to Preprogrammed Messages – Premises (Status)
Message – 1.
• Press [next ] (if necessary) to advance to the next preprogrammed message to change.
• Press [chg] to input a new message for the selected preprogrammed message.
• Use the chart and the dial pad keys to input the new message. When finished press [save].
• Continue programming messages as required.
• Press the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
To Next Page
Loading...
