Comdial DX-80 - Page 260

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-210
• Press [show ]. The DB Item Select screen displays.
To program Auto Log-Off and/or Log-On Again timers:
• Input 08-05, then press [save ]. This advances to the Auto Log-Off programming screen.
• Press [chg] to change the Auto Log-Off timer until the appropriate time displays.
• Press [next ] to advance to the Log-0n Again screen.
• Press [chg] to change the Log-On Again timer until the appropriate time displays.
To program settings for the built-in modem:
• Input 04-15, then press [save ]. This advances to the Built-in Modem programming screen.
• Press [show ]. This advances to the Directory Number screen.
• To change to the built-in modem directory number, press [chg].
• Input the appropriate directory number (must be a valid extension directory number as allocated in
System Application – Numbering Plan – Extension Directory Numbers).
• Press « to temporarily store this data.
Or...
• Press [next ] to advance to the modem Baud Rate screen.
• Press [chg] until the appropriate baud rate displays.
• Press the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«.
• Press any key at the program title page (as it requests) to enter the Main Menu.
• Select PC-DBA from the main menu.
• Select Programming from the PC-DBA menu. Then press «.
To program Auto Log-Off and/or Log-On Again:
• Use ¢£¤¥ to highlight “System Application” and then press «.
• Use ¢£¤¥ to highlight “Category 1” and then press «.
• Use ¢£¤¥ to highlight the database item “PC-DBA Connection – Auto Log-Off/Log On Again” as
required.
• Press « until the appropriate value displays.
• When all changes are made press the ° (escape) key to exit this database programming screen. You will
see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.