DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-224
• Use the cursor arrows to highlight “Category 2” and then press Enter.
• Use the cursor arrows to highlight the database item “SMDR Output” for the Extension to be changed.
(Note: You may need to use the Page Up/Down keys to view the extension for which changes are
required.)
• Press Enter. Each time that enter is pressed the value of this database item is updated.
• When all changes are made press the ESC (escape) key to exit this database-programming screen.
You will see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
Ø Press “N” to abort changes and leave all data unchanged.
Ø Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
Ø Press “N” to abort changes and leave all data unchanged.
Ø Press “Y” (yes) to continue with the save operation.
• Press ESC (escape) again to return to the Database Programming menu.
• To program call logging conditions (Outgoing/Incoming/Account Code):
• Use the cursor positioning arrows to highlight “Call Handling” and then press Enter.
• Use the cursor arrows to highlight “Category 2” and then press Enter.
• Use the cursor arrows to highlight the database item “SMDR Call Output – Outgoing/Incoming/Account
Code” as required.
• Press Enter. Each time that enter is pressed the value of this database item is updated.
• Continue to make other changes to the Call Output settings as required.
• When all changes are made press the ESC (escape) key to exit this database-programming screen.
When you will see the “Exit This Feature?” prompt, press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
Ø Press “N” to abort changes and leave all data unchanged.
Ø Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
Ø Press “N” to abort changes and leave all data unchanged.
Ø Press “Y” (yes) to continue with the save operation.
• Press ESC (escape) again to return to the Database Programming menu.
• To program the (CIL) Call Information Log serial port baud rate (CIL X_RATE):
• Use the cursor positioning arrows to highlight “System Resource” and then press Enter.
• Use the cursor arrows to highlight “Modem & Serial Port” and then press Enter.
• Use the cursor arrows to highlight the database item “CIL X_Rate.”
• Press Enter. Each time that enter is pressed the value of this database item is updated.
• When all changes are made press the ESC (escape) key to exit this database-programming screen.
You will see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
Ø Press “N” to abort changes and leave all data unchanged.
Ø Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
Ø Press “N” to abort changes and leave all data unchanged.
Ø Press “Y” (yes) to continue with the save operation.
• Press ESC (escape) again to return to the Database Programming menu.
• Continue making other programming changes or exit PC-DBA programming.
To Next Page
Loading...
