DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-229
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press ° (escape) again to return to the Database Programming menu.
Program CO Lines into the tenant group:
• Use ¢£¤¥ to highlight “CO Line” and then press «.
• Use ¢£¤¥ to highlight “Category 1” and then press «.
• Use ¢£¤¥ and ³´ to highlight “Tenant Group” for the appropriate CO Line to program.
• Press « until the appropriate tenant group number displays.
• Use ¢£¤¥ and ³´ to highlight “Tenant Group” for the next CO Line to program and continue as
above until all CO Lines are programmed in the tenant groups.
• When all changes are made press the ° (escape) key to exit this database programming screen. You will
see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press ° (escape) again to return to the Database Programming menu.
Program Tenant Group Calling:
• Use ¢£¤¥ to highlight “Call Handling” and then press «.
• Use ¢£¤¥ to highlight “Tenant Calling” and then press «. The Tenant Group Calling screen and
table displays. Intercom calling is allowed from one tenant group to another.
• Use ¢£¤¥ to highlight the “From” and “To” calling designation for the Tenant Group.
• Press « until the appropriate setting displays. (Calling is allowed/denied from the Tenant Group listed on
the left to the Tenant Group listed across the top.
• When all changes are made press the ° (escape) key to exit this database programming screen. You will
see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press ° (escape) again to return to the Database Programming menu.
• Continue making other programming changes or exit PC-DBA programming.
Note: Changes made via PC-DBA are not updated to the DX-80 system memory until a “SEND” function has
been performed. Please refer to the Programming section of this manual to learn more about this procedure.
To Next Page
Loading...
