DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-231
• Assign Extension COS as required to follow the appropriate Digit Interval.
• Assign CO Line COS as required to follow the appropriate Digit Interval.
Programming via the DET (Digital Extension Terminal)
Note: [back], [next], [show], [chg], [bksp], and [save] are LCD interactive button operations. Use the
three buttons below the LCD display to actuate the associated operation.
• Enter Database Administration using the feature code !+* and then enter the DB Admin password
“++++++++.” (Note: This eight-character password can be changed.)
• Press [show ]. The DB Item Select screen displays.
Program Digit Interval(s) and assign Extension/CO Line COS to Digit Intervals:
• Input 05-01-1~3-001~100 (where 1~3 is the Tenant Group and 001~100 is the Interval to program). Then
press [save]. This advances to the “FROM” column of the tenant group and interval selected.
• Press [chg] to change the start of this interval range (beginning FROM…).
• Input the new starting digit sequence, then press [save].
• Press [next ] to advance to the “TO” column of the tenant group and interval selected.
• Press [chg] to change the end of this interval range (up …TO).
• Input the new ending digit sequence, then press [save].
• Press [next ] to advance to Extension or CO Line COS as required for change.
• Press [show ]. The DAY Allowed parameter displays for the Extension or CO Line COS.
• Press [next ] to advance to the EVE Allowed COS for the Extension or CO Line COS.
Or…
• Press [show ] to program COS allowed settings for this Digit Interval. COS 0 displays.
• Press [next ] and [back] until the appropriate COS to change displays.
• Press [chg] until the appropriate setting (Y/N) displays.
• Press the Hold button to return to the previous menu level.
Or…
• Press the Volume button (up or down) to return to the DB Item Select screen.
Program Extensions for the COS to follow:
• Input 01-101~156-05~06 (where 101~156 is the Extension and 05 is DAY Class Of Service and 06 is EVE
Class Of Service.)
• Press [chg] until the appropriate COS displays for the selected service mode.
• Press the Hold button to return to the previous menu level.
Or…
• Press the Volume button (up or down) to return to the DB Item Select screen.
Program CO Lines for the COS to follow:
• Input 02-740~755-04~05 (where 740~755 is the CO Line and 04 is DAY Class Of Service and 05 is EVE
Class Of Service.)
To Next Page
Loading...
