DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-258
• Input the UCD Group to program as the VM Hunt Group (usually 24). Then press «.
• Use ¢£¤¥ and ³´ to highlight “Members.” Then press «.
• Use ¢£¤¥ and ³´ to highlight the member to program. Then press «.
• Input the extension number of the analog port to program as this member of the VM UCD Group. Then
press «.
• Continue until all analog extensions connected to VM are programmed.
• When all changes are made press the ° (escape) key to exit this database programming screen. You will
see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press ° (escape) again to return to the Database Programming menu.
Program Voice Mail Hunt Group and Call Handling digits:
• Use ¢£¤¥ to highlight “Extension Application.” Then press «.
• Use ¢£¤¥ to highlight “Voice Mail Table.” Then press «.
• Use ¢£¤¥ to highlight the Tenant Group to program (usually “1”). Then press «.
• Press « until the selected UCD Group number displays (usually 24).
• Use ¢£¤¥ to highlight the various call handling digit parameter to program. Then press «.
• Input the digit string for the selected call type. Then press «.
• Continue until all programming is complete.
• When all changes are made press the ° (escape) key to exit this database programming screen. You will
see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press ° (escape) again to return to the Database Programming menu.
Program Voice Mail Dialing Ratio:
• Use ¢£¤¥ to highlight “Call Handling.” Then press «.
• Use ¢£¤¥ to highlight “Category 3.” Then press «.
• Use ¢£¤¥ to highlight VM Dialing Ratio – Tone Time or Inter-Digit Time. Then press «.
• Press « until the required time displays.
• When all changes are made press the ° (escape) key to exit this database programming screen. You will
see the prompt: “Exit This Feature”; press “Y” for yes.
To Next Page
Loading...
