DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-2
Extension Classes of service - all calls allowed
Account Code Access Code - 79
Programming via the DET (Digital Extension Terminal)
Note: [back], [next], [show], [chg], [bksp], and [save] are interactive LCD button operations. Use the
three buttons below the LCD display to actuate the associated operation.
• Enter Database Administration using the feature code ! * and then enter the DB Admin password
“########.” (Note: This eight-character password can be changed.)
• Press [show ]. The DB Item Select screen displays.
• Input 05-02.
• Press [save ].
• Press [show ]. The Account Code database item “LENGTH” displays.
• Press [chg] (change) until the appropriate account code length displays.
• Enter the new length and then press [save].
• Press [next ]. The account code database item “PASSWORD” displays.
• Press [show ]. The ID Number of the account code to be changed is required.
• Enter the account code number 001-600 to change/display.
• Press [show ]. The existing programming displays. (“NULL” = empty.)
• Press [chg].
• Enter the account code using the digits 0-9 on the dial pad. When the correct number of digits are entered
(according to the designated length), press “save.” This database item is then updated.
• Press [next ]. The Class of Service for this account code displays.
• Press [chg] until the appropriate Class displays for this account code password.
• Press [next ]. The item “DISABLED” displays. This setting is used temporarily disable the use of a particular
Account Code without removing its programming. “DISABLED” means that this account code is active.
• Press [chg] to select “Y” or “N” to disable this account code password.
• Press [next ] to continue programming other account codes. Or exit programming.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«. The program title page displays.
• Press any key at the program title page to enter the Main Menu.
• Select PC-DBA from the Main Menu. The PC-DBA menu is then shown.
• Select Programming from the PC-DBA menu.
• Use ¢£¤¥ to highlight “RESTRICTION” and then press «.
• Use ¢£¤¥ to highlight “Account Code Table” and then press «. The cursor is now positioned on
the database item - account code “LENGTH.”
• Press « to change this item. Or move the cursor to another item. Note: Changing the account code length
will delete all previously programmed account codes!
• Move the cursor as required to the database item to be changed.
To Next Page