DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-9
Voice Mail is set to UCD Group 24 (directory number 433).
Programming Abstract
• Change Monitor Time if required.
• Program Predefined Call Forward for each extension if calls should always be directed to voice mail from
that extension.
Programming via the DET (Digital Extension Terminal)
Note: [back], [next], [show], [chg], [bksp], and [save] are interactive LCD button operations. Use the
three buttons below the LCD display to actuate the associated operation.
• Enter Database Administration using the feature code !#* and then enter the DB Admin password
“########.” (Note: This eight-character can be changed.)
• Press [show ]. The DB Item Select screen displays.
• Input 03-34.
• Press [save ]. This advances to the VM Monitor_T screen.
• Press [chg] (change) until the appropriate VM Monitor Time displays (in seconds.)
• Press [back ] or [next ] for other programming. Or exit programming.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«.
• Press any key at the program title page (as it requests) to enter the Main Menu.
• Select PC-DBA from the main menu.
• Select Programming from the PC-DBA menu.
• Use ¢£¤¥ to highlight “CALL HANDLING” and then press «.
• Use ¢£¤¥ to highlight “Category 3, then press «. The cursor is now positioned on the database
item - “Dial Delay Time.”
• Use ¢£¤¥ to highlight “VM Monitor Time” and then press « until you reach the appropriate play
time. (Range is 10-60 seconds.)
• When you have completed all changes, press the ° (escape) key to exit this database programming
screen. You will see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press ° (escape) again to return to the Database Programming menu.
• Continue making other programming changes or exit PC-DBA programming.
Note: Changes made via PC-DBA are not updated to the DX-80 system memory until a “SEND” function
has been performed. Please refer to the Programming section of this manual to learn more about this
procedure.
To Next Page
Loading...
