DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-48
• Continue making other database changes.
• Exit programming mode when changes are complete.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«.
• Press any key at the program title page (as it requests) to enter the Main Menu.
• Select PC-DBA from the main menu.
• Select Programming from the PC-DBA menu.
Program the extension for the ability to use External Call Forward:
• Use ¢£¤¥ to highlight “Extension.” Then press «.
• Use ¢£¤¥ to highlight “Category 2.” Then press «.
• Use ¢£¤¥ to highlight “ECF Operation.”
• Then press « until the appropriate value displays.
• Continue making changes for other extensions as required.
• When you have completed all changes, press the ° (escape) key to exit this database programming
screen. You will see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press ° (escape) again to return to the Database Programming menu.
Program the various system External Call Forward parameters:
• Use ¢£¤¥ to highlight “Call Handling.” Then press «.
• Use ¢£¤¥ to highlight “Category 2.” Then press «.
• Use ¢£¤¥ to highlight either database item “External CFW – Service” or “External CFW – Talk Time.”
Then press « until the appropriate value displays for the data item.
• When you have completed all changes, press the ° (escape) key to exit this database programming
screen. You will see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press ° (escape) again to return to the Database Programming menu.
• Continue making other programming changes or exit PC-DBA programming.
To Next Page
Loading...
