To Next PageTo Next Page
Need help?Do you have a question about the COMETA WAVE PLUS and is the answer not in the manual?
General| Category | Medical Equipment |
|---|---|
| Model | WAVE PLUS |
| Input Impedance | >100 MΩ |
| Wireless Technology | Bluetooth |
| Noise Level | <1 μV RMS |
| Connectivity | Bluetooth |
| Power Supply | Rechargeable battery |
Instructions for operating the Wave Plus system for EMG and accelerometer data acquisition.
Details on essential, optional, and accessory parts of the Wave Plus system.
Information about the wireless EMG and accelerometer modules.
Description of the base unit's front panel LEDs and rear panel connections.
Overview of the docking module's function and LED indicators for battery charging.
Configuration and operation of the Wave Plus system in analog output mode.
Requirements for analog devices to be connected to the Wave Plus system.
Detailed pin-out diagram for the analog output connector (J26).
Connecting the Wave Plus system to a PC via USB for data acquisition.
Utilizing the external trigger connector for data capture synchronization in digital mode.
Details on trigger input, output signals and Strobe IO for synchronization.
Methods for synchronizing Wave Plus with third-party devices via USB or analog signals using trigger ports.
PC system requirements for connecting to the Wave Plus system via USB.
Explanation of the LED status lights on the Wave Plus base unit.
Description of the LED status light on the EMG electrode unit.
Information on using single-use pre-gelled electrodes with the Wave Plus system.
Steps for recharging the electrode batteries using the charging module.
Interpreting the LED status on the charging module during battery recharge.
Understanding the LED indicators for electrode battery charge status.
Recommendations for long-term storage and mitigating wireless LAN interference.
Managing electromagnetic interference and proper handling of EMG probes.
Guidelines for using the transportation case and safety warnings during use.
Checking patient sensitivity and usage guidelines for children and cooperative subjects.
Instructions for positioning and connecting piezoresistive sensors for gait analysis.
Identification of parts within the Wave Plus system that can be repaired by the user.
Step-by-step guide for replacing the battery in the electrode modules.
Technical characteristics of the electrode batteries, including voltage, capacity, and recharge cycles.
Instructions for cleaning the base unit and electrodes to prevent liquid infiltration.
Essential safety warnings regarding battery disassembly and short-circuiting.
Guidelines for the proper disposal of batteries and system components.
Information on the labels and composition of the base unit.
Details of the label on the Wave Plus docking station brief case.
Specifications and details for the Wave Plus inductive charger label.
Information regarding the adhesive labels applied to the electrode parts.
Detailed technical specifications for the Wave Plus base unit, including frequency, channels, and power.
Technical specifications for the Wave Plus EMG modules, covering transmission and power.
Technical specifications for the Wave Plus footswitch sensors.
Specifications for the docking module and net feeding power supply.
Further technical details including input impedance, CMRR, SNR, and environmental conditions.
Information on the suitability of the system and the maximum radio link distance.
