2.1 How to use it
To use Wave Plus, two pre-gelled disposable electrodes for each channel have to be applied to the
subject. The EMG acquisition module is applied on the surface electrodes using a snap connector.
If required by the exam, piezoelectric sensors are applied for the identification of plantar supports; the
foot-switch acquisition module is applied to the sensor by the appropriate cables.
To use the Wave Plus system only as an inertial acquisition system, that is by using only the
accelerometers included in the probes and not the EMG signal acquisition, it is sufficient to attach or
strip the probes in the designated place, without any need for pre-gelled electrodes.
Wave Plus system can be used by doctors, paramedics and technicians.
To use Wave Plus system, please, read carefully the instructions in the relative chapter.
To Next Page
Loading...