6.3 Inductive charger (inside the brief case, up to two units):
6.4 Elettrodi:
The electrodes are made of two parts; the upper part is permanently pad printed with the brand “Wave
Plus” on the top. The lowe part is permanently pad printed with the brand “Cometa” on one side and
“Wave Plus” on the other side.
To the upper part is applied an adhesive label as follow:
<EMG CH#> or <FSW #>
with the number assigned to the electrode (from 1 to 16), or to the FSW (“A” or “B”).
The labels of the two parts of the electrodes are visible after having taken apart the probe by separating
the upper and the lower part
To the upper part is applied a label with these informations:
REF XXX
LOT XXXX
To Next Page
Loading...