Commend Symphony BF - Page 12

Basic user – Web interface Symphony BF
12 1.4/0222
 Default Button: Press the default button of the Symphony BF station to cancel the call.
 Button <x>: Press the selected button of the Symphony BF station to cancel the call.
 Button Enter: Press the enter button of the Symphony BF station to cancel the call.
 Button Menu: Press the menu button of the Symphony BF station to cancel the call.
 Any Input: Any detected input state change will cancel the call.
 Any Button: Any button of the Symphony BF station will cancel the call (if connected, including
WSDD 53V/WSDD 59V module buttons).
 Any Input or Button: Any button or any detected input state change will cancel the call.
 Input Button <x> rising edge: Cancels the call when the normally open contact is being closed.
 Input Button <x> falling edge: Cancels the call when the normally open contact is being
opened.
 Module on Input <x> Button <x>: The selected WSDD 53 V or WSDD 59V module button can-
cels the call.
 Auto answer Delay (s): In this field, the delay (in seconds) for the auto answer function (0 = no
delay) can be configured. Select the entry “Auto Answer” in the drop-down list Answer call to en-
able this field (see above
). Default: “5”
NOTE:
The number and the labelling of the buttons in this drop-down list depend on the station version
used and the number of configured direct dialling modules in use. For further information, contact
your system administrator.
NOTE: Input has to be activated and configured as standard input
To select an input or a direct dialling module button in this drop-down list, the respective option
has to be activated in the tab input.
NOTE: Input has to be activated & configured as 3-button or 9-button module
To select an input or a direct dialling module button in this drop-down list, the respective option
has to be activated in the tab input.
NOTE:

If an Auto answer delay (s) of “0” is configured, no incoming call tone is played back.
 If the Auto answer delay (s) is changed from “0“ to another value, the factory default incoming
call tone is restored.
3.7