2-8 Setting
Up
Your CDTVIP System
Connection
for
a
Monitor
or
Monitor-Style
Television
Set
To
connect the
CDTV
IP
sound
to
a stereo monitor
or
monitor-
style stereo television set, insert
one
end
of
the stereo
cables
into the right
and
left audio outputs
on
the
back
of
the
CDTV
IP.
Then insert the other
ends
into the corresponding
audio inputs
of
the monitor
or
TV.
If
your monitor
or
TV
has only a monophonic
speaker,
you
can
convert the two stereo channels
from
the
CDTV
IP
to
a
single
channel that can
be
plugged
into
any
monophonic
audio
input
by
using an optional
cable
called a
"Y"
adapter.
This adapter
can
be
purchased at electronics stores
and
in the electronics
or
hardware departments
of
many
large
consumer
stores.
Just
insert the two phono
plugs
at
one
end
of
the
"Y"
adapter into
the two audio outputs
on
the
back
of
the
CDTV
/P.
Then insert
the single
plug
at the other
end
of
the
"Y"
into
audio
input
jack
of
the monitor
or
TV.
Connection
for
a
Stereo
System
If
your stereo system has a set
of
RCA-type
audio
input
connectors
(labeled
Auxiliary,
Aux,
CD,
Tape,
VCR
Audio,
TV/Aux,
etc.),
you
can use these connectors
to
attach the
stereo output cables
from
the
CDTV
IP.
To
connect the
CDTV
IP
to
your
stereo system, insert the
cables into the right
and
left
audio
output connectors
of
the
CDTV
IP.
Then insert the other
ends
of
the
cables
into the
corresponding audio input
jacks
of
the stereo system.
If
you
have a non-standard
(i.e.,
non-RCA)
type
of
connector
on
your stereo equipment, there
is
probably
an
adapter that will
enable
you
to make the
audio
connection.
See
your dealer
for
information.
To Next Page
Loading...