Setting
Up
Your CDTV/P System 2-3
Setting
Up
Your
CDTV/P
1.
Remove
the
CDTV
IP
and accessories from
the
box.
Remove all packing material.
2.
Place
the
CDTVIP on a stable, level surface away from
heat, moisture, or vibrations. Do
not
block
the
ventilation slots on the top or sides
of
the
CDTV
IP
or the
ventilation fan slots
on
the
back.
REMEMBER:
To
protect
against
electrical
shock,
disconnect
all
equipment
(monitor,
VCR,
printer,
etc.)
from
power
while
connecting
the
CDTVIP.
3. Connect
the
CDTVIP to a display device (monitor or
cable-ready TV set).
The
actual connection depends
on
The type
of
monitor or TV
set
you are using. See
CONNECTING
THE
DISPLAY
DEVICE
below for
detailed connection diagrams and instructions.
Once you connect
the
display device you can begin to use the
CDTVIP by setting up the mouse or remote control (as
explained below) and connecting
the
power cables. Before you
do this, you should read Chapter 3 for important information
on
how to insert a disk
in
the
CDTV I
P.
To Next Page
Loading...