Getting Started 3-5
REW
/PLAY
/PAUSE/FF/STOP
These buttons control
CD
transport functions
i.e.,
moving
forward,
back,
etc.).
Using
the
Mouse
The mouse controls a pointer
on
the system selection screen
by
gliding the mouse in the direction
you
want the pointer to
move.
To
use the mouse, place it
on
a flat surface with the transmitter
window
!see
illustration) pointing
toward
your
CDTV
IP.
To
activate the mouse buttons,
press
the
ON
button located
on
the side
of
the mouse. The motion
of
the
mouse
against a
flat
surface !mouse
pad,
table,
desk,
etc.)
causes
the pointer
on
the
top
of
the screen to
move.
The mouse
can
be
picked
up
and
placed
onto a different spot without
causing
the pointer
on
the
screen to
move.
The mouse
has
a special battery-saving
feature
that will
automatically tum the
mouse
off
if
no
activity
has
been
detected after one minute. If the mouse deactivates itself
during
use,
simply
press
the
ON
button
again.
Since
the mouse
is
a
very
sensitive pointing
device
only a
small
area
is required
for
use.
To
operate it
effectively,
you
need
a clear spot approximately 5
or
6 inches in diameter with a
surface that allows the
ball
inside
to
roll
smoothly without
slipping.
As
indicated in the table
above,
the left
and
right mouse
buttons
are
used the same
way
that the A
and
B buttons
on
your
COTY
remote controller
are
used:
that
is,
to
select items,
back
up
to
previous menus, etc.
Generally,
the left button
is
used
to
advance through a menu to the next item
and
the right
button
is
used to return
to
the previous item.
NOTE:
In
order
to
use
the
mouse
with
a
specific
CDTV
title,
that
title
must
be
designed
for
mouse-mode
control.
Check
the
instructions
that
come
with
each
CDTV
title
for
more
information
about
using
the
mouse.
To Next Page
Loading...