4-4 Using the CDTV!P
As
A
CD
Player
If
a disk has more
than
20
tracks, the track numbers above
20
will
not
be displayed at first. They will scroll into view when
you move down at
the
bottom
of
the grid.
To
eliminate the current sequence
of
tracks displayed on the
grid, select the Program Clear button.
Intro
scan
Select this button to hear the first ten seconds of each track on
the
disk,
in
the
order shown on the display grid. Select this
button
again, or select Stop, to cancel Intro Scan.
Loop
The
loop option allows you to define a loop that automatically
repeats any section of the CD. The loop can
be
any length from
under a second to
the
entire CD.
Select this button before CD play has started to toggle between
loop and normal play. In normal
play,
CD play ends at the
conclusion of the last track. In loop play (with the loop arrow
highlighted) play will automatically start again with the first
track at the end
of
the
last track.
Select this button once while the CD is playing to define
the
start point
of
the loop. The button symbol will change to a
double arrow,
with
the
left-hand arrow highlighted. The track
will continue to play.
Select the button again when you wish to define the end point.
The
right-hand arrow on the button will then also become
highlighted, and play will jump back to
the
loop start point.
Play will continue to jump back to the start point when the
end point is reached as many times as you wish.
To
cancel the loop mode and allow play to continue beyond the
end point, select the
Loop
button again.
The
arrow will return
to a single, unhighlighted image.
To Next Page
Loading...