Commodore PC 20 - Page 199

Graftabl
Purpose:
loadS additional character data into a table in memory for use
with a color or graphics adapter.
Syntax:
graftabl
Comments:
Graftablloads a table of the ASCII characters, 128 through 255,
into memory. If you have a color or graphics adapter, this table
lets you display foreign language characters
when you are in
graphics mode.
After graftablloads the character table, it displays the following
message:
GRAPHICS CHARACTERS LOADED
You can load the graphics table only once each time you start
MS· DOS. If you try to load the table a second time, graftabl
dispiays the following message:
GRAPHICS CHARACTERS ALREADY LOADED
Note This command increases the size of MS· DOS resident in
memory.
Example:
To load the graphics table into memory, type the following:
graftabl
MS-DOS Commands 61 I
Graftabl
Loading the graphics
table into memory