Commodore PC 20 - 0.3.5 Running Wordstar in 132 Column Mode

34 Operations Guide
Monochrome Graphics Mode
If your monochrome software has a Hercules driver, install that
driver
when operating under the monochrome graphics mode.
Refer to
your application software's manual for details of Hercules
driver installation. Otherwise, install
the monochrome driver; or
you can configure your ATI Graphics Solution to the emulation
mode and install the Color/Graphics drivers on your application
software. Either way
your graphics software will run on your
Commodore PC
monochrome monitor.
The
MT, MG1, and MG2 utility commands are equivalent
respectively
to the DlAG, HALF, and FULL utilities available on the
Hercules diskette. MT disables monochrome graphics, MG 1 allows
for 1 page
of graphics, and MG2 allows for 2 pages of graphics. MG2
is usually required for most monochrome graphics programs such
as Lotus. MG 1 allows for co-existence with a Color/Graphics
Adapter.
Color/Graphics Mode
If your Color/Graphics software has a Plantronics driver (such as
Lotus Symphony), install that driver when operating under the
Color/Graphics mode. Otherwise, install the Color/Graphics driver.
0.3.5 Running WordStar in 132 Column Mode
To run WordStar in 132 column mode, you need to modify the
WS.COM file on your WordStar Diskette. Follow these simple steps:
Type
DEBUG WS.COM (return)
Type E cs:248 (return)
lYpe 2B (return)
Type E cs:249 (return)
Type 84 (return)
Type W (return)
0.3.6 Diagnostics
A diagnostics program has been supplied to help you determine if
your ATI Graphics Solution Adapter is working properly. Details on
the operation of this program are outlined in Section D.7,
Diagnostics and Troubleshooting.