Commodore PC 20 - Page 221

The restore program sets the exit codes in the following manner:
o Normal completion
1
3
No files were found to restore
Terminated by user
4 Terminated
due to error
Refer to the backup command in this chapter for more
information.
Example:
To restore the file invest. mnt from the backup disk in drive A to
the \ irsharpe directory on drive C, type the following:
restore a: c:\irsharpe\invest.mnt
Press the RETURN key to let MS· DOS know that the backup disk is in
drive A. Then once MS·DOS has restored the file, use the dir or
type command to make sure that the flIe was restored properly.
!
MS-DOS Commands 831
Restore exit codes
Restoring a file