Compaq Armada 1500C series - I;O Fixture Connector

Computer Removal and Replacement Procedures 5-35
5.17 I/O Fixture Connector
To remove the I/O fixture connector:
1. Disconnect the AC power and any external devices (Section 5.3.1).
2. Remove the battery pack (Section 5.3.3).
3. Remove the DualBay device (Section 5.3.4).
4. Remove any PCMCIA cards (Section 5.3.5).
5. Remove the keyboard (Section 5.6).
6. Remove the microphone/display cable cover (Section 5.10).
7. Remove the clutch covers/display assembly (Section 5.11.1).
8. Remove the top cover assembly (Section 5.12).
9. Remove the LED status panel board (Section 5.13).
10. Remove three screws securing the I/O fixture to the rear of the computer.
Figure 5-34. Removing the Screws from the I/O Fixture Connector