Computer Removal and Replacement Procedures 5-19
5.8 Hard Drive
To remove the hard drive and retaining clip:
1. Disconnect the AC power and any external devices (Section 5.3.1).
2. Remove the battery pack (Section 5.3.3).
3. Remove the DualBay device (Section 5.3.4).
4. Remove any PCMCIA cards (Section 5.3.5).
5. Raise the keyboard (Section 5.6).
6. Remove hard drive retaining clip by squeezing both ends of the retaining clip 1
together, then lifting up 2.
Figure 5-17. Removing the Hard Drive Retaining Clip
To Next Page
Loading...
