Computer Removal and Replacement Procedures 5-27
5.12 Top Cover Assembly
To remove the top cover assembly:
1. Disconnect the AC power and any external devices (Section 5.3.1).
2. Remove the battery pack (Section 5.3.3).
3. Remove the DualBay device (Section 5.3.4).
4. Remove any PCMCIA cards (Section 5.3.5).
5. Remove the keyboard (Section 5.6).
6. Remove the microphone/display cable cover (Section 5.10).
7. Disconnect speaker connectors 1 and touchpad cable 2 and RTC battery connector
3 from the system board.
Figure 5-26. Disconnecting the Speaker Connectors, Touchpad Connector, and RTC
Battery Connector From the System Board
To Next Page
Loading...
