5-26 Computer Removal and Replacement Procedures
5.11.2 Display Assembly
To remove the display assembly:
1. Disconnect the AC power and any external devices (Section 5.3.1).
2. Remove the battery pack (Section 5.3.3).
3. Remove the DualBay device (Section 5.3.4).
4. Remove any PCMCIA cards (Section 5.3.5).
5. Remove the microphone/display cable cover (Section 5.10).
6. Remove the clutch covers (Section 5.11.1).
7. Remove two screws from each clutch and the clutch tension plate that secure the
display to the base enclosure 1.
8. Disconnect the display cables from the base enclosure 2.
9. Lift the display assembly from the base enclosure.
Figure 5-25. Removing the Display Assembly
Reverse the procedure to replace the display assembly.
CAUTION: Attach the ground cable before attaching the display cables when
replacing the display assembly to avoid damaging the display and ground cables.
CAUTION: Use the new screws from the screw kit when replacing the display
assembly. Using the old screws can damage the display assembly and ground
cables.
To Next Page
Loading...
