5-30 Computer Removal and Replacement Procedures
5.13 LED Status Panel
To remove the LED status panel board:
1. Disconnect the AC power and any external devices (Section 5.3.1).
2. Remove the battery pack (Section 5.3.3).
3. Remove the DualBay device (Section 5.3.4).
4. Remove any PCMCIA cards (Section 5.3.5).
5. Remove the keyboard (Section 5.6).
6. Remove the microphone/display cable cover and microphone (Section 5.10).
7. Remove the clutch covers/display assembly (Section 5.11.1).
8. Remove the top cover assembly (Section 5.12).
9. Remove the 2 screws 1 securing the status panel board.
10. Disconnect the LED status panel board 2 from the system board.
Figure 5-29. Removing the LED Status Panel Board
To replace the LED status panel, reverse the steps.
To Next Page
Loading...
