Computer Removal and Replacement Procedures 5-39
5.19 External Computer Components
This section describes the removal and replacement procedures that do not require
access to the internal components of the computer. This includes:
n Computer logo
n Computer feet
5.19.1 Computer Logo
The computer logo is on the outside of the display assembly and can be replaced if
damaged. To replace the logo:
1. Use a small, sharp, flat-bladed screwdriver to pry up the existing logo.
2. Clean the area with a clean dry cloth.
3. Apply the new logo.
5.19.2 Computer Feet
There are four locations where the computer feet can be applied. To replace the
computer feet:
1. Peel the old foot from the computer. Use a razor blade if needed to lift a corner of
the foot free from the base cover.
2. Clean the area where the new foot is to be applied with a clean dry cloth.
3. Install the new foot, pressing it firmly into place.
To Next Page
Loading...
