5-8 Computer Removal and Replacement Procedures
5.3.5 PCMCIA
Remove any installed PC (PCMCIA) cards before performing any service on the
computer. To remove a PC Card:
1. Rotate the PC card eject lever to the forward position 1.
2. Press the PC card eject button 2.
3. Pull the PC card out of the PC Card slot 3.
Figure 5-6. Removing the PC Card
To install a PC card, insert the card into the slot and press firmly until it is seated.
NOTE: Before replacing the system board, the PC card eject levers must be in the
forward position. See Section 5.18 on removing the system board.
To Next Page
Loading...
