Computer Removal and Replacement Procedures 5-13
5.6 Keyboard
To remove the keyboard:
1. Disconnect the AC power and any external devices (Section 5.3.1).
2. Remove the battery pack (Section 5.3.3).
3. Remove the DualBay device (Section 5.3.4).
4. Remove any PCMCIA cards (Section 5.3.5).
5. Turn the computer bottom side up.
6. Remove the screws near the rear of the computer from the battery and DualBay
compartments and from the bottom of the base 1. These screws remove the
keyboard.
NOTE: It is not necessary to remove the screws 2 unless you are going to remove the
top cover assembly.
7. Remove the upper screws 2 from the battery and DualBay compartments. These are
the remaining base enclosure screws.
Figure 5-11. Removing the Keyboard Screws
To Next Page
Loading...
