Computer Removal and Replacement Procedures 5-33
10. Disconnect the DC-DC converter from the system board.
11. Pull the DC-DC converter away from the plastic tab separating the DC-DC converter from the I/O
fixture connector 1.
12. Remove the DC-DC converter 2.
Figure 5-32. Disconnecting and Removing the DC-DC Converter
To replace the DC-DC converter, reverse the steps.
CAUTION: The DC-DC converter board is secured by a short T-8 screw. Do not use
the long T-8 screw to secure the DC-DC converter board. Use of the long screw can
damage the system board.
To Next Page
Loading...
