Service Reference Guide, dc7700 433612-001 8–29
Removal and Replacement Procedures - Ultra-Slim Desktop (USDT) Chassis
8.20.3 Type 3 Battery Holder
1. Pull back on the clip 1 that holds the battery in place, then remove the battery 2.
2. Insert the new battery and position the clip back in place.
3. After the battery has been replaced, reverse the disassembly procedure.
4. Plug in the computer and turn on power to the computer.
5. Reset the date and time, your passwords, and any special system setups, using Computer
Setup. Refer to the Computer Setup (F10) Utility Guide.
To Next Page
Loading...
