Service Reference Guide, dx2000 uT 359782-002 6–3
Removal and Replacement Procedures— Microtower (µT) Chassis
6.3 Front Bezel
1. Prepare the computer for disassembly (Section 6.1, “Preparation for Disassembly”).
2. Remove the access panels (Section 6.2, “Access Panel”).
3. Grasp the bottom of the front panel below the lowest air vent and pull the panel out and up to
release it from the chassis.
To install the front bezel, insert the top two latches into their respective holes in the chassis and
push the bezel in until it is fully seated.
✎
When replacing the front bezel, ensure that the top of the front bezel is flush with the top of the
chassis before pressing it into place.
To Next Page
Loading...
