Service Reference Guide, dx2000 uT 359782-002 6–21
Removal and Replacement Procedures— Microtower (µT) Chassis
4. To release the battery from its holder, push away the metal clamp that extends above one
edge of the battery 1. When the battery pops up, lift it out 2.
5. To insert the new battery, slide one edge of the replacement battery in with the positive side
pointing to the metal retaining clamp as shown, until the clamp snaps over the other edge of
the battery.
✎
After the battery has been replaced, use the following steps to complete this procedure.
6. Replace the computer cover or access panel.
7. Plug in the computer and turn on power to the computer.
Reset the date and time, your passwords, and any special system setups, using Computer Setup.
To Next Page
Loading...
Need help?
General