Technical Reference Guide
Compaq Deskpro EN Series of Personal Computers
Desktop and Minitower Form Factors
Third Edition - September 1998
8-1
Chapter 8
BIOS ROM
8.
Chapter 8 BIOS ROM
8.1
INTRODUCTION
The Basic Input/Output System (BIOS) of the computer is a collection of machine language
programs stored as firmware in read-only memory (ROM). The BIOS ROM includes such
functions as Power-On Self Test (POST), PCI device initialization, Plug ‘n Play support, power
management activities, and Setup. This chapter includes the following topics:
♦ Boot/reset functions (8.2) page 8-2
♦ Memory detection and configuration (8.3) page 8-3
♦ Desktop management support (8.4) page 8-4
♦ PnP support (8.5) page 8-19
♦ Power management functions (8.6) page 8-21
The firmware contained in the BIOS ROM supports the following operating systems and
specifications:
♦ DOS 6.2
♦ Windows 3.1
♦ Windows for Workgroups 3.11
♦ Windows 95
♦ Windows 98
♦ Windows NT 3.5 and 4.0
♦ OS/2 ver 2.1
♦ OS/2 Warp
♦ SCO Unix
♦ DMI 2.0
♦ Intel Wired for Management (WfM) initiative
The microprocessor accesses the BIOS ROM as a 128-KB block from E0000h to FFFFFh. The
BIOS data is shadowed in a 64-KB block in the upper memory area. The BIOS segments are
dynamically paged in and out of the 64-KB block as they are needed.
NOTE:
This chapter describes BIOS in general and focuses on aspects of BIOS unique
to this particular system. For detailed information regarding the BIOS, refer to the
Compaq Basic Input/Output System Technical Reference Guide.
To Next Page
Loading...
