Compaq Evo N600c Series - Replacing a Multibay Battery Pack

4–4 Hardware Guide
Battery Packs
Replacing a MultiBay Battery Pack
Ä
CAUTION: To prevent loss of information when removing a
MultiBay battery pack that is the only power source available to the
system, initiate Hibernation or turn off the computer before
removing the battery pack.
1. Close the display, then turn the computer bottom-side up
1
.
2. Insert or remove the battery pack.
❏
To remove a battery pack, slide the MultiBay release
latch
2
on the bottom of the computer, then pull the
battery pack out of the MultiBay
3
.
❏
To insert a battery pack, slide the battery pack into the
MultiBay until it is seated
4
.
Replacing a MultiBay battery pack
3. Turn the computer right side up, then open the display.
4. If the computer is in Hibernation, slide the power switch to
resume operation.
229045-002.book Page 4 Friday, September 21, 2001 11:16 AM