Compaq Prolinea Family - Chapter 6.6 CD-ROM Drive Jumper Settings

6 OFF Synchronized Spindle Disabled
7 OFF SCSI Pin 29 Disabled
8 key
9 OFF Spin Up with Start Unit Command
10 ON Parity Checking Enabled
11 ON Initiate SDTR Message at Power-On and Reset
12 OFF Unit Attention Enabled
13 OFF Write Protect based on Mode Page
14 OFF Reserved
15 OFF Terminator Disabled
16 OFF Terminator Power Disabled
===========================================================================
Chapter 6.6 CD-ROM Drive Jumper Settings
The jumper settings for the quad speed IDE CD-ROM drive are shown in
Figure 6-24 and 6-25.