Compaq Prolinea Family - Chapter 5.4 External Components

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
The computer power switch should be turned off before you disconnect any
cables.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
3. Disconnect the power cord from the electrical outlet and then from the
computer.
4. Disconnect all peripheral device cables from the computer.
IMPORTANT: During disassembly, label each cable as you remove it, noting
its position and routing.
Chapter 5.4 External Components
This section describes removal and/or replacement procedures that do not
require access to the internal components of the computer. This includes:
o Compaq Logo
o Rear Corner Bezels
o Feet
o Cable Lock
o Unit Cover
o Front Bezel
o Rear Bezel
Compaq Logo
The Compaq logo is secured to the front bezel with adhesive. If the
original logo came off, complete the following steps to replace the logo
without removing the unit cover assembly:
1. Clean the recessed area in the front bezel where the logo is to be
installed with a clean, damp cloth.
2. Remove the protective cover from the back of the replacement logo and
press it into place as shown in Figure 5-3.