For assistance in the removal and replacement of a particular subassembly,
see Chapter 5, "Removal and Replacement Procedures."
Table 2-2. Processor Test Error Codes
===========================================================================
Error
Code Description Recommended Action
===========================================================================
101 - xx CPU test failed Replace the system board and retest.
---------------------------------------------------------------------------
102 - xx Coprocessor or Weitek 1. Run the Configuration and
Error Diagnostics Utilities.
2. Replace the coprocessor and retest.
3. Replace the processor
(if applicable) and retest.
---------------------------------------------------------------------------
103 - xx DMA page registers Replace the system board and retest.
test failed
104 - xx Interrupt controller
master test failed
105 - xx Port 61 error
106 - xx Keyboard controller
self-test failed
---------------------------------------------------------------------------
107 - xx CMOS RAM test failed The following steps apply to 107 - xx
through 109 - xx:
108 - xx CMOS interrupt test
failed 1. Replace the battery/clock module and
retest.
109 - xx CMOS clock test 2. Replace the system board and retest.
failed
---------------------------------------------------------------------------
110 - xx Programmable timer Replace the system board and retest.
load data test failed
113 - xx Protected mode test
failed
---------------------------------------------------------------------------
114 - 01 Speaker test failed 1. Check system configuration.
2. Verify cable connections to speaker.
3. Replace the system board and retest.
===========================================================================
Table 2-3. Memory Test Error Codes
===========================================================================
Error
Code Description Recommended Action
===========================================================================
200 - xx Memory machine ID The following steps apply to 200 - xx and
test failed 202 - xx:
202 - xx Memory system ROM 1. Replace the system ROM and retest.
checksum failed 2. Replace the system board and retest.
---------------------------------------------------------------------------
203 - xx Write/Read test The following steps apply to 203 - xx
To Next Page
Loading...
