EasyManuals Logo

Compaq Prolinea Family User Manual

Compaq Prolinea Family
197 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
Diskette drive cannot write 1. Diskette is not formatted. Format the
to a diskette. diskette.
2. Diskette is write protected. Either use
another diskette that is not write
protected or disable the write protection
on the diskette.
3. Writing to the wrong drive. Check the
drive letter in your path statement.
4. Not enough space is left on the diskette.
Use another diskette to write the
information.
---------------------------------------------------------------------------
Diskette drive cannot 1. Diskette is not formatted. Format the
read a diskette. diskette.
2. Using the wrong diskette type for the
drive type. Use a diskette that is
compatible with the drive.
3. Reading the wrong drive. Check the drive
letter in your path statement.
4. Diskette drive has been disabled by
Computer Setup. Run Computer Setup and
enable the diskette drive.
===========================================================================
Monitor Problems
This section identifies some quick checks for monitor related problems.
Table 2-18. Solutions for Monitor Problems
===========================================================================
Problem Possible Solution
===========================================================================
Characters are dim. The brightness control is not set properly.
Adjust the brightness control.
---------------------------------------------------------------------------
Screen is blank. 1. A screen blanking utility could be
installed. Press any key. If the display
reappears, you have a screen blanking
utility installed.
2. The brightness needs adjusting. Adjust
the brightness control.
3. Screen save has been initiated. Press any
key or move the mouse to light the
screen.
---------------------------------------------------------------------------
No sound. Check the adjustment of the volume control
on the WSS Sound Board on the rear of the
computer.
---------------------------------------------------------------------------
Garbled characters on the The ANSI.SYS driver is not in the CONFIG.SYS
screen are mixed with text. file. Add the ANSI.SYS driver to the
CONFIG.SYS file by adding the following
line: DEVICE = C:\DOS\ANSI.SYS
---------------------------------------------------------------------------
Monitor overheats. There is not enough ventilation space for
proper airflow. Leave at least 3 inches
(7.6 cm) of ventilation space. Also, be sure
there is nothing on top of the monitor to

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Compaq Prolinea Family and is the answer not in the manual?

Compaq Prolinea Family Specifications

General IconGeneral
BrandCompaq
ModelProlinea Family
CategoryDesktop
LanguageEnglish

Related product manuals