Altitude at waypoint: sets the response time of the calculation of the arrival height to the
next turnpoint. This setting affects several data (arrival height above the waypoint, arrival
altitude MSL, etc...).
Altitude at goal: sets the response time of the calculation of the arrival height to goal.
This setting affects several data (arrival height above the goal waypoint, arrival altitude
MSL at goal, etc...).
TAS (C-Probe): sets the response time of the calculation of the true airspeed. The true
airspeed is available when C-Pilot EVO is connected to the optional external sensor C-
Probe.
Restore default values: restore factory presets.
In any configuration page, you will find two buttons that you may use to switch menu page or to go
back immediately to the navigation page.
To Next Page
Loading...