being invalid, will be greyed.
In the case of very poor reception, if the GPS module is not able to complete the fix for approx 30
minutes, the receiver will start a new search. All the satellites will disappear from the screen and
newly acquired ones will be shown in the bottom part of the display.
If the GPS signal is completely absent for several hours, the receiver will shut itself off to reduce the
power consumption. To restart it, you will have to power cycle C-Pilot EVO.
Hardware info
Here you will find some parameter of the hardware of C-Pilot PRO.
Battery voltage: from 3.2 V to 4.2 V.
Battery current: shows the instantaneous current consumption of the device or the recharge
current when a charger is attached.
Backlight level: backlight intensity in percentage.
Light sensor reading: ambient-light level measured by the light sensor.
Raw pressure reading: shows the un-calibrated reading of the pressure sensor.
Sensor calibration: shows the calibration parameters of the pressure sensor. Each sensor
is individually calibrated at Compass.
Pressure reading: current atmospheric pressure.
Used flight-log memory: amount (percentage) of internal memory used for flight logs.
Used USB memory: amount (percentage) of USB memory in use.
Serial number: the unique serial number of your device.
Kernel date: date when the kernel of the operating system currently installed was created.
To Next Page
Loading...