Starting up
Switching on and off C-Pilot PRO
You can switch on C-Pilot PRO by pressing the power button underneath the left rubber cover
(Figure 5). There is no need to open the cover: just press on the Compass logo, impressed on the
cover, for approximately five seconds. When you see the C-Pilot EVO logo on the display, you
can release the button. The device will complete the start up procedure in more or less 20 seconds.
To turn the device off, press briefly the power button, then press the “ok” button in the confirmation
alert that appears.
Figure 5: connectors and buttons are on the left side of the device
You can also use the “off” button in the main menu ( Figure 2), shown after pressing the “C-
Pilot PRO” button in the navigation page.
Touch-panel calibration
After switching the device on, if necessary, you may calibrate the touch panel (factory pre-
calibrated) by pressing for approx one second the power button; when the confirmation alert shows
up, press again the power button. Follow the instructions (Figure 6). The calibration procedure takes
more or less 10 seconds to complete.
Due to its quality, you will rarely need to recalibrate the touch panel. It will become necessary when
you feel that the panel does not react to your commands or touch. Please do not drag your finger
while calibrating the instrument: simply touch the centre of the taget. It is sensible to pressure: you
can use it while wearing gloves as well as with your bare fingers.
To Next Page
Loading...