Technical Information on On-board Flash Programmer FP-40 Aug. 31, 2023 (Second edition)
17
X3.3V/X5V power supply
This can be used as the power supply from FP-40 to the target system. The two pins of the target connector are X3.3V
(3.3V) and the 20 pins are X5V (5V), both of which guarantee ±5% accuracy and can supply up to 200mA. The rise time
upon power-on is 2ms. 3.3V or 5V can be used depending on the C-Flash setting, but they can't be used simultaneously.
For details on the settings, refer to "4.3 Target Settings" in "Onboard Flash Memory Programmer FP User's Manual".
These power supplies are equipped with a protection circuit that cuts the power supply if an overcurrent is detected due
to a short circuit on the target. To confirm that power is normally supplied to the target, the voltage of VTref is measured
by software processing after power is supplied, and if the voltage of VTref is lower than the [minimum input voltage of
VTref (Pin 1)], the power output is stopped to protect FP-40 itself.
If these pins are not used, leave them as NC.
External I/O function signals
These signals are for the FP-40's external I/O functions. EX_BSY, EX_NG, EX_STARTn, EX_OK, EX33_BSY, EX33_OK,
and EX33_STARTn are assigned to the target connector respectively. The target connector signals are normally
connected to the target system in which the CPU to be written is mounted, but these signals are intended to be
connected to an external production system or other controller device that controls FP-40. Please refer to “External I/O
functions of FP-40” for detailed specifications.
If the External I/O functions of FP-40 is not used, leave these signals as NC.
The specifications are the same as those of the conventional FP-10 model.
To Next Page
Loading...