Computherm Q7 - Page 26

d. At this point the temperature of switch PROG should be set,
which is indicated on the display of the device by ashing the
temperature value to be set ( °C by default). Set the desired
temperature using the large and buttons, then
press the “PROG” button.
e. Then, the start time of switch PROG should be adjusted, which is
indicated on the display of the device by ashing the time value
to be adjusted ( by default). Set the desired time using the
large and buttons, then press the “PROG” button.
f. Following this, the temperature of switch PROG should be
set, which is indicated on the display of the device by ashing
the temperature value to be set ( °C by default). Set this
temperature level of switch PROG using the large and
buttons, then press the “PROG” button.
26