g. The next step in programming is the adjustment of the start time
of switch PROG , which is indicated on the display of the device
by ashing the time value to be adjusted ( by default). The
adjustment process of switches PROG – PROG can be done
(the same way as switch PROG is adjusted) by repeating the
“e”-“f” steps.
If you do not want to activate any more switches for the
selected day(s), then press the “PROG” button without
changing the start time of the next switch from the default
. This way the programming of the selected day(s) is
nished, the thermostat offers another day to be programmed
and the programming can be continued from step “c”.
If all the switches (PROG – PROG ) are activated for the selected
day(s), then after setting the temperature value of PROG , the
programming of the selected day(s) is nished, the thermostat
27
To Next Page
Loading...
