Concept2 SkiErg - Maintenance; Safety Information for PM4 Rechargeable Battery Pack; Miscellaneous; PM Troubleshooting

14
1210
MISCELLANEOUS
Cleaning the PM
Useaclothlightlydampenedwithwateronly.Donotspraywithacleanerorleaveintherain.
Formulas Used
Watts=2.80/(sec/meter)^3
Calories/Hour=Kcal/hr=(watts)x(4)x(0.8604)+300
Do not:
• Opentheplasticcase
• Dropthebatterypack
• Allowbatterypackpinstotoucheach
other or any metal object
• Useifdamagedorleaking
• Trash,incinerate,crush,etc.
Do:
• UseonlyinaPM4;ifnotusedinPM4,storecarefullysopinsarenotshorted
• Keepcleananddry
• Usebetween0˚and40˚C
• Charge(skiorplugPM4intoUSB)afterprolongedperiodofnon-use
• Keepbatterypackawayfromchildren
• Recycleproperly
 WARNING:Ifbatteriesleak,donotusethem.Batteryuidsarecorrosiveandcandamageeyes,irritateskin,etc.If
contact occurs, wash affected area immediately and thoroughly with water.
Safety Information for PM4 Rechargeable Battery Pack
Portfortheoptional
Polar™heartrate
receiver.
Bottom View of PM
Battery cover
PM3
Race system jacks
PM4
Back View of PM
Reset here
Flywheel sensor cable must be connected
hereforthePMtooperate.
USBportforconnectingto a computer. Beveled
cornersonUSBcableplugfacethebackofthe
monitor. DO NOT FORCE when plugging in.
See concept2.com/pm for current information.
PM TROUBLESHOOTING
1. IfthePMmalfunctionsordoesnot“wakeup,”tryoneofthefollowing:
• Insertapaperclip(PM3)orpen/penciltip(PM4)intotheresetholeonthebackandpresslightly.
• Removethebatteriesfor30minutesandinserttwonewalkalineD-Cell(LR20)batteries.
2. To change language: press [MENU/BACK]untilscreenstopschanging.Pressfthgreybuttononright,thenpresssecond
greybuttononrighttwice,andselectyourlanguage.Alternately,holddownCHANGEUNITSandCHANGEDISPLAYand
reset monitor. You can then select your desired language.
3. IfyourcomputerdoesnotrecognizethatyourPM3/PM4isconnectedtoittryoneofthefollowing:
• Useanothercomputerand/orUSBcable.
• Removebatteriesfor30minutesthenreinsertbatteriesandtryagain.
Refer to concept2.com/pm for more information and software updates.
Battery compartment: Loosen screw and press
thumbstrike in direction shown to open.
PM3
PM4
Notes:
1)RemovebatteriesorbatterypackfromthePM3orPM4if
monitor will not be used for a period of four months or more.