EasyManua.ls Logo

Conel FLOW CUT BOX - Safety Regulations for Maintenance, Inspection and Installation Work; Unilateral Modification and Spare Parts Manufacturing; Unproved Usage; Scope of Delivery

Conel FLOW CUT BOX
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2.4
Safety Regulations for maintenance, inspection and
installation work
Theuseroftheunitshouldensurethatallmaintenance,inspeconorinstallaonworkiscarriedout
byauthorisedandqualiedskilledpersonnel.Theusermustalsomakecertainthattheyhavecarefully
studiedtheoperanginstrucons.
Inprincipleallworkontheunitshouldonlybecarriedoutwhileitisstaonary.Pumpsorunits,usedfor
pumpingoruidswhichcouldbeinjurioustohealthmustbedecontaminated.Aercompleonofthe
workallsafetyandprotecvedevicesmustbereedandacheckshouldbemadethattheyarefully
funconal.
Beforestarngupagain,thepointslistedunderthesecon“Commissioning”shouldbecompliedwith.
2.5
Unilateral modification and spare parts
manufacturing
Modicaonsorchangestotheunit/installaonshouldonlybecarriedoutaerconsultaonswiththe
manufacturer.Originalsparepartsandaccessoriesautho-risedbythemanufacturerareessenalfor
compliance with safety requirements.
Theuseofotherpartscaninvalidateanyclaimsforwarrantyorcompensaon.
2.6
Unproved usage
Theoperangsafetyoftheunitisonlyguaranteedprovidedthattheunitisusedinaccordancewith
theseoperaoninstrucons.Thelimitvaluesgiveninthedatasheetshouldundernocircumstancebe
exceeded.Theseinstallaonandoperaoninstruconsdonotsupersedeorexcludethefollowingof
generallyvalidregulaonsandstandards.
3.
Scope of delivery
Synthectank,pre-assembledandwired,readyforinstallaonwithrubberfeet,tankmounng
supports/securingbrackets,inletseals,non-returnvalveforexternalaachment,overowprotecon
andalarm,ventwithintegratedodourlter,built-inmotorunitwithshreddingsystemandmoisture
sensor level control.
Pleasenotethatthesealwithpart-number43075164fortheconneconofaseparateventlineis
included as an accessory (see chapter 14).
33

Table of Contents