Conel FLOW CUT BOX - Commissioning; Maintenance

9.
Commissioning
ATTENTION!
/ Theliingunitisnowoperaonal.
/ Plugintheunitandcarryoutafuncontest.Allowwatertoowintothetank.Theliingunitturns
on as soon as the electrical power supply is established and the water level in the tank is above the
switch on level.
/ Checkallconnecons/pipelinesforleaks.
/ Inaddion,observethespecicaonsinDINEN12056-4,DINEN12050-3andDIN1986/100.
10.
Maintenance
ATTENTION!
Before carrying out any maintenance work on the unit, all power lines should be disconnected from
the mains and care should be taken that the unit cannot be inadvertently switched back on. Check the
pressure line for damage.
To avoid danger if the power cable is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person.
Change the acve charcoal filter:
/ At least once a year.
/ In case of unpleasant odours.
/ Wherewaterhasdischargedthroughthelter.
In case of decreasing pump performance remove possible deposits and other substances from the tank.
Inaddion,observethespecicaonsinDINEN12056-4,DINEN12050-3andDIN1986/100.Incase
of problems, please contact your CONEL supplier.
40