Conel FLOW CUT BOX - Transport; Electrical Connection

6.
Transport
ATTENTION!
Theliingunitmustnotbethrownordroppedduringtransportorinstallaon.
Theliingunitmustnotbeliedbythepowercable!
7.
Electrical connection
/ Observethecorrectoperangvoltage(see“TechnicalData“).
/ Never place the power plug in water.
/ Connecttheliingunittoaproperlyinstalledelectricalsocket(incompliancewithVDEandthe
powersupplycompanyregulaons)protectedbyatleasta10A(slow-blowing)fuse.
/ ForunitsofproteconclassicaonI,allexposedconducvepartsareconnectedwithaprotecve
earthconductor.Beforetheunitisputintooperaon,anelectricallyskilledpersonmustcheckthat
theprotecveearthcableisproperlyconnected.
/ Temperatureshigherthanthosepermiedcausethepumptobeshutobythetemperature
limiter.Aerthetemperaturelimiteristriggered,disconnectthepumpfromtheelectricsystem
beforecorrecngthecauseofthefault,otherwiseitwillswitchonautomacallyoncecooleddown.
36