Conel FLOW CUT BOX - Steps to be Taken in Case of Blockage

15.
Steps to be taken in case of blockage
ATTENTION!
When there is a blockage or fault, water sources which drain into the unit should not be used.
Figure 11
/ Disconnect from electrical supply by withdrawing plug and ensure that it cannot be inadvertantly
reconnected.
/ Remove cap seal (1) from tank.
/ Insertascrewdriverorelectricaldrillandclearapossibleblockageofthecungsystemby
manuallyrotangtherotorsha.
Ifrotangtherotorshafailstocleartheblockagethenthecompletemotor/pumpingunitmustbe
removedfromthetankforinspeconandtheblockageclearedbyhand(seepage42,g.9).
ATTENTION!
Caremustbetakenwhenhandlingthemotor/pumpingunitasthereisadangerofinjuryfromthecung
tool in the hydraulic system.
1
2
1
44