Consumer Cellular Link - Getting Started; Installing a Microsdhc Card; Removing the Microsdhc Card and the Nano-SIM Card

6 7
TABLE OF CONTENTS
CTIA Requirements .......................................................................................88
Distractions ......................................................................................................89
Product Handling .......................................................................................... 90
Electrical Safety ..............................................................................................94
Radio Frequency Interference .................................................................. 95
Explosive Environments ..............................................................................97
Specifications ................................................................................... 98
Support .............................................................................................99
Warranty ......................................................................................... 100
GETTING STARTED
INSTALLING A microSDHC™ CARD
Power off your phone before installing or removing the
microSDHC card.
1. Place your finger in the slot at the lower left of the back
cover to lift and remove the cover.
2. If the battery is installed already, remove it.
3. Hold your microSDHC card with the metal contacts
facing down and slide it into the microSDHC card slot.
4. Install the battery.
5. Press the cover gently back into place until you hear a
click.
REMOVING THE microSDHC CARD AND
THE nano-SIM CARD
1. With the phone powered off, open the back cover and
remove the battery.
2. Press the soft block that keeps the cards in place and
slide the nano-SIM card or the microSDHC card out.